phone stand

prusaprinters

This is an other remix from a great object : simple, elegant, and usefull, largely inspired from https://www.thingiverse.com/thing:2120591 I found this design : https://www.thingiverse.com/thing:4139558 is even better than mine ! (it has a cable retainer) The purpose of mine was to not strain the cable when charging the phone. Plus i wanted to be able to use it for video chatting (it frees your hands, this is great !) I used sketchup and meshlab. Edit : i ve created a V2 version, which is basically the same only with "rounded corners" (i used the Fredo6 sketchup extension). Print Settings Printer Brand: Deltaprintr Printer: Deltaprintr Kit Rafts: No Supports: Yes Infill: 10 Filament: No brand. PLA Notes: To minimize support, i ve printed it on the side. Support should be added "everywhere". Support density 15% and ziz zag. 4h30min, 62g of PLA that is 20.88m of PLA (with 10% infill and 15% support density) I usually print the first few layers at "low speed" (30mm/s) to make sure the adhesion is ok then i increase the speed by 160%. Category: Mobile Phone