Phone Holder

thingiverse

I've uploaded two styles of the phone holder I designed last year, each roughly the same size but with one key difference - the larger version has a deeper phone cradle. Print the regular design for phones that are less than 0.55 inches thick or 14mm to be precise. On the other hand, print the large design for phones no thicker than 0.93 inches or 23.5mm. Made with PLA, these holders should be printed on their side and supports will likely be needed in the gap of the phone cradle section. Infill isn't crucial, as I've tried printing it at 0%, 20%, 40%, and 100% - however, I wouldn't advise going beyond two outlines. While a raft does help, I have managed to print successfully without one on occasion.