PHONE FINGER LOOP

pinshape

DON'T DROP YOUR SMART PHONE ANOTHER TIME!!! PRINTS ALL AT ONCE!!! This finger loop is perfect for holding your massive smart phone in one hand without the risk of dropping it. The Loop and Arm fold out easily as you slide your finger into place. The grip of the loop around your finger works incredibly well, but just right - not too tight or too loose - depends on the size of your fingers. It lays flat when you remove your finger and is only 3mm thick. Designed to be 3D printed with flexible filament (TPU, Ninjaflex, etc.). Unless you change the scale, the square part prints to 1" square and should fit most standard 1" double-sided sticky tape (0.94" width or something close to it). Just make sure to trim off the tape at the Folding Loop Arm, and remember to clean both sides of the surfaces with rubbing alcohol if possible before applying. The loop is 21mm inside diameter. If you'd like custom adjustments made to this design, let me know. Also, depending on your printer and experience with flexible filaments, try printing slow - something like 20mm/s or so - for most 3D printers to keep the quality up. I can print this on my Tevo Tornado in 15 minutes at 20mm/s using ideaMaker slicer. If you have any questions, feel free to ask away.