Phone Cradle

thingiverse

This is a straightforward phone cradle that I specifically designed for the HTC One M9 Plus, but it should work with any phone of similar size. Note: I made it slightly wider to fit my phone's case, so if you don't have a case, it might be a bit looser fitting. You can print this without support by standing it up or laying it on its side. If printing upright, some supports for the build plate are helpful for the small fillets at the bottom, but they're not necessary. Edit: After printing, I noticed that this thing might be over-engineered in terms of strength. To address this, I removed the back support and replaced it with a smaller 45-degree support in the back. I don't think this will compromise its integrity under normal use and it cut the print time down by about one-third.