Phone Charger

grabcad

For the phone charger for example I used mine and I started with the bottom and then made my way to the top. So I used the top plane and created a rectangle extrude that up then using the front plane made another rectangle dimensioned it and it created smaller then I made a line in between the middle and made to smaller squares on the top after do that for both sides and extrude cut it had made the inside to go into the block and what I did for that what was created to longer rectangles extrude cut one of them and the other extrude base Bose very little bit then I sued a helix spiral for the cord and used the sweep tool