Phone and tablet holder - remixed

thingiverse

This is a remix of the multiple device charging stand by wittless (http://www.thingiverse.com/thing:1471349). I created slots that are wider to hold phones and tablets in cases securely. The slots are positioned from front to back at 1.5cm, 1.5cm, 1.7cm, 2.5cm and 2.5cm respectively. They have fairly tight tolerances for standard cases and probably wouldn't fit an Otterbox in the front slots but the back ones should work. Taller tablets in the back slots could still tip this over despite having taller supports and additional feet at the back, however placing one phone in the front slots or moving the tablet to the next 2.5cm slot up will prevent this issue from occurring. I modeled it in Blender, sliced it in Cura and printed on a Monoprice Maker Select (modified) at 210 degrees with extreme cooling - temp readout hovered around 190, using a 60 degree heated glass bed with hairspray adhesion in black eSun PLA+. The layer thickness was .25 at a print speed of 40mm and 35% infill which took roughly 14 hours. I wanted it to look good in my living room. I'm posting the .blend file for anyone who wants to modify this design, you can download Blender at www.blender.org. The feet could be slightly longer in the back but doing so might make it too big for a 200x200 print bed. Thanks to wittless (http://www.thingiverse.com/wittless/about) for creating the initial design. Printer: Monoprice Maker Select (modified extruder, fan, gear, etc.) Rafts: No Supports: No Resolution: .25 Infill: 35 Notes: I printed this with 2 brims but it's not necessary if you're getting good bed adhesion - no warp, no pulling.