Phoenix EZ3D Table Holder

thingiverse

I swapped out the warped aluminum plate for a sturdy 214mm square glass plate, making this an all-purpose (LEFT, RIGHT) table holder to securely position both the heat plate and the glass. Any remarks or suggestions are much appreciated. Using the EZ3D software, I found that STL files cannot be uploaded due to their large size, which is why I've also included a SolidWorks sketch file for your convenience. To get it printed accurately to size, I had to pass the file through an online converter (http://www.greentoken.de/onlineconv/) that converts STL files. Unfortunately, even with this conversion, the imported model came in very small. To rectify this issue, I magnified the image 11 times its original size and then re-imported it from EZ3D software. However, this still didn't bring it to the desired dimensions. It was only after deleting that initial part, importing the same STL file again, and enlarging it a further 2.2 times did I achieve the correct print dimensions. The reasons behind these quirks remain unclear. Maybe having metric measurements for the sketch might resolve some of these issues.