Phoenix Drummer Hand v1

thingiverse

Hello everyone DISCLAIMER *This project is non-profit and is currently under development to implement improvements. This device was created so that a 10 years old kid could play the drums, it is based on the Phoenix Hand V2, which was scaled for X and Y at 120% and Z at 100%. The adjustment bracelet, string control, pins for finger assembly and others are the same as those of the Phoenix Hand V2, take into account the scale previously described. The device supports drumsticks from 7A to 5B, but other diameters can be used by modifying the liners. For assembly it is required: - 2 M6 hexagonal nuts with their respective screws (For adjusting the stick holder) - 4 M4 hexagonal nuts with their respective screws (To assemble the support fingers) *Check the length of the screws and cut them if necessary to avoid excesses. Everything was printed on a PRUSA i3 MK3S, the recommended material is PETG for the whole device (But PLA could work), except for the liners which are soft TPU or some other material like Silicone; all of them with an infill of 40% and a layer height of 0.02mm. Any questions, you can leave a comment or send a DM.