Phillips OneBlade Stand

thingiverse

Simple charging stand that locks in the charging cable. The cable will not push-out when placing trimmer in base. There is a hole that shows charging light status. This design allows the cable to be fed thru the bottom and locked in with a push-in part that engages the the thumb/finger grip on the charging cable. Installing cable: The charging cable needs to match the orientation of the trimmer when docked. Push the end of the cable up through the bottom with a blunt rod (see pic) until the tip emerges enough to connect to the trimmer. The lock is installed from the side. Note the orientation as the edge has a slight draft to match the exterior draft. Next revision will include a keying feature to verify orientation. Removing cable: There are 2 holes opposing the locking piece. These holes allow for a paperclip or similar to remove the locking piece for any reason. The cable should not be pulled to remove, but rather pushed down from the top.