Philips (Hue Motion) Sensor - holder

prusaprinters

<p>Designed a quite simple holder for the Philips Hue Motion Sensor that sits over the door.<br/> With a 20 degrees angle, so there is bigger chance of the sensor too recognize someone at the door.</p> <p>The magnetic part screws into place using a normal M3 screw through threaded hole.<br/> And the lip(lower part of the model) gets squeezed between the wall and door seal.<br/> Therefor I uploaded 3 versions with different thickness of the lip(1, 1.5 &amp; 2 mm lip).<br/> Also the height of the "lip"/the part that gets between the door seal is 11 mm.<br/> (more sizes on request)</p> <p>I used the 1 mm and that was good enough.</p> <h3>Print instructions</h3><p>No needs of support of any sort.<br/> Infill is suggested. I printed mine with 20%.<br/> More perimeters(walls) might be good for rigidity.<br/> Bracket/holder for a corner, can be printed as imported.</p>