Phantom Fx-61 Flying Wing Motor Mount

thingiverse

I've created a motor mount that supplants the original mount from the Fx-61 Flying Wing, which is too fragile to accommodate most motors. I break mine every time on the last landing with a fixed propeller. This new design is 15mm longer than the standard and boasts an enlarged surface for gluing, perfectly fitting the Phantom body. Moreover, it becomes extremely well ventilated. The motor screw spacing measures 25mm and 19mm, with a 3mm diameter screw. I typically print this mount in ABS with a 2% size increase to compensate for thermal shrinkage of the material. The model was printed at a 50% infill rate.