Phantom 3 Pro simple gimbal lock

thingiverse

I'm using a simple, no-frills design for my Phantom 3 Pro gimbal lock and love the look of some other designs shared here, but they often rubbed against the foam inside the hardshell backpack case. This design doesn't have that problem! The ring around the camera should slide right on; if it's a bit too tight, a tiny amount of sanding may be needed to get the perfect fit – I emphasize just a small amount. I'm not sure if this design will work for the P3A since I don't know if the camera ring size is the same. Enjoy! Print Settings Printer: XYZ DaVinci 1.0 AIO Rafts: No Supports: Yes Resolution: 0.2mm Infill: 50% Notes: I used 1.75mm ABS filament for this print. The supports are necessary for the jog where the lock attaches to the upper part of the camera/gimbal assembly. I set a medium density for the supports.