Petsfang for Prusa MK3

thingiverse

Petsfang for Prusa MK3 So, with the success of the v2 Petsfang and many other iterations of my design, I've had several Prusa I3 owners asking if I could create a version specifically designed around the MK3. The new mount incorporates the upper half of the stock MK3 mounting plate unchanged and features the stock MK3 paired with the Bond Tech dual gear extruder. The lower portion is redesigned to capture the E3Dv6 heat sink air, exhaust it to the sides, away from the nozzle, and provide a support for the duct. I will adapt it as needed during testing. It locates the Pinda Probe in the same location as stock for leveling from the probe points. As with all my ducts, it's intended to be printed flat face down with supports from the build plate only. Make sure to cut threads for the 3 holes in the base holding the duct before you mount any parts. It will be a lot easier to mount the duct with those threads pre-cut. In theory, with the MK3 dual rails, the mount should be very solid even with the additional height. I'll let you figure out the best orientation for the other parts. Please feel free to send me info on this. As with all other mods, I will listen and evaluate your suggestions. You can reach me as a PM in Facebook or an email to: davidpetsel@petsfang.com Dave