Petsafe Spray Commander remote button Cover V3

thingiverse

I've found this remote a bit finicky so it's easy to accidentally spray the dog with citronella especially if you put it in your pocket or have more than one thing in your hand. This cover leaves the "beep" button exposed but needs to be slid back to allow the 2 spray buttons to be accessed. I printed this cover in PLA on an Anet A8 and it works okay without any support. It also works fine with support, but it's a bit hard to get the support out from the inside. It is quite a tight fit so I suggest sliding it with a thumb in the gap underneath or modify it to be looser in Tinkercad. The hole is too small for the provided hand loop to go through, so you need to detach it then reattach once the cover is on - this stops the cover from being lost if slid right off.