Permanent Shower Curtain Minder (Magnetic)

prusaprinters

<p>We all know the problem. Standing in the bathtub shower with the shower curtain trying to hug you while you are busy cleaning yourself.</p> <p>This is no more. Print out these bad boys, snap them onto the shower curtain and they will now neatly latch your shower curtain onto your steel bathtub.</p> <p>I printed mine in PETG, but PLA should work as well, unless you shower in boiling water.</p> <p>Slap some 12mm x 2mm round magnets into the friction fit hole and then clasp them onto the curtain with the snappy bit on the inside and the magnetic thingy on the outside.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Prusa</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Mk2.5s</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>0.2</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>20%</p></div> <p><strong>Filament:</strong> Prusament PETG White</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>Print the bottom one with the hole up and the top one with the large surface laying on the bed. No other magic is required.</p></div> Post-Printing ============= <p>Post printing I used some wet sanding to level the infill on the top piece to a smoother finish. Not needed, but just gives that little bit extra.</p> <h3>How I Designed This</h3> <p>I searched around for something already designed, and while I found a few shower curtain minders that were magnetic, they seemed to require me to manually set the magnet onto the curtain every time which I couldn´t be bothered with.</p> <p>I therefore designed these guys, printed a test or two and then decided they were good enough for me and to be shared with the rest of the world.</p> </p></p></p> Category: Bathroom