Pergo Samsung Tab S 10.5 Support

thingiverse

Bought my wife a Samsung Tab S 10.5 and I'm impressed - it's amazing, but holding onto it for any amount of time is a challenge. I watched her fidgeting with it and told her I could make her life easier. So, I did! I had her hold the tablet at the angle she preferred, took some measurements, then printed out a custom mount. The mount itself uses a 1/2" schedule 40 PVC pipe that can be cut to any desired length. To minimize assembly time, I designed it to print in two pieces that can be glued together with super glue and held in place by M3 8 mm long screws. Later on, I created a plug that fits snugly into the bottom of the PVC pipe. To make it easy to print, I positioned it right-side up like a mushroom growing with supports. Once the supports are broken away, the plug should slide smoothly into the pipe. If you want a custom angle, simply tell me the mm measurement from the pipe to the back of the support. In my stock model, this measurement was 70 mm - understanding where I measured will help clarify things.