PerfLamp2

cults3d

This lamp employs the same fundamental geometry, albeit on a smaller scale, with 7-pointed stars now taking the form of heptagons. The net outcome of these modifications is that this one prints in approximately 15 hours and 10 minutes using an 80 mm/sec print speed and a 0.2 mm layer height. This lamp was printed in roughly 26 hours and 1 minute, utilizing an 80 mm/sec print speed and a 0.2 mm layer height. The design of this lamp allows it to accommodate any one of several LED lights known as "puck" lights. These lights can be powered either by batteries or wall power. A blog page linked below offers recommendations for wall-powered LED lights: http://birkbinnard.com/blog/wall-powered-led-lights/