pequeño medidor para altura de discos de corte y fresado, caliper

thingiverse

This is a small analog gauge for adjusting the height of cutting discs and milling on milling machines and grinders. It's also useful for other measurements, obviously. It's printed in PLA at 205 degrees with a resolution of 0.3. The parts include 4 x 15mm metric screws and two magnets in the base that are 10 x 1 or 10 x 1.5 mm. I used strips from the metric ruler sets you can buy at big home improvement stores and furniture kits as my guide. I hope it's useful to you. Update: Check out the last picture with the pin poking up. That way, by printing this modified piece that removes those four holes and putting the tape on this side, you can make both measurements with this piece alone. Sorry about the confusion, but sometimes a potato gets a little slow. I hope everything is going well for you. The new piece is number 4.