Peppa Pig - Car

thingiverse

This is a Peppa Pig toy that I made for my little one. All the details were printed on white PLA, then painted with acrylic and finished with two coats of water-based lacquer. You'll find two different versions of the car body - short and long. If you want to print this toy successfully: Make sure to enable supports for the car body and back seat before printing. You might need to smooth out the car body a bit so the shafts fit properly. For the wheels, try using a drill bit to clean up the wheel hole and sanding the shaft. This will help them run smoothly. Insert the wheel into the car body before gluing the shaft in place - be careful not to get the wheel stuck with glue, or it won't move! I used cyanoacrylate to glue all the parts together. Designing This Toy Everything was created using 123D Design software. I've included the original files for you to use and modify as needed.