Peon 230 Remix Quadcopter

thingiverse

<iframe width="560" height="315" src="https://www.youtube.com/embed/GbE_auraCpo" frameborder="0" allow="accelerometer; autoplay; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe> This is a remix of the Peon 230 with a lower profile, just 25mm inside, and even stronger arms. It's really compact, this frame supports props up to 50xx Maximum. Just be careful not to use bigger props - they won't fit. The FC and esc are stacked together, leaving some room on the back for the RX and VTX. Plus, there's an immortal T integrated into the bottom plate. You can print it with PLA or any other material you like, but don't forget to print the Motor Softmount and Gopro Support in TPU. Here are the infill settings: - Brace: 35% - Top and bottom: 50% - Arms: between 35% and 100%, depending on your flying style On my build, I used: - Motors: DX2205 - Props: Dalprop 5040 - FC: Xracer F4 - ESC: 4 in 1 Hakrc 30A - VTX: eachine TX806 - RX: TBS nano + immortal T - Cam: Foxeer micro falkor - LI-Po 4S 1300mAh The total weight is just 397g. You'll need to add these non-printed parts: - 12 x M3x10mm screws for the Top/Bottom frame - 4 x M3x25mm screws for FC & ESC - 8 x M3x12mm screws for Arms - 1 x M3 x 10mm screw for antenna fuse - 8 x M3 Nyloc nuts for Arms Have a great flight!