Penny Tri Spinner (Pennies encased inside)

thingiverse

This is a remix of 2ROBOTGUY's penny fidget spinner. I made one change - adding a 0.5mm top layer to each penny slot so that pennies can be fully enclosed inside the spinner. Instructions: I sliced the spinner using Cura 2.5 and then used GCode Simulator to visualize layers from gcode. Next, I opened the gcode and added an M600 command (pause) just before the layer where the hole for the pennies is closed. When printing, the printer should pause once penny slots are done. Add four pennies to each slot, which should be even height with the top of the spinner at this point, and resume the printer. It should perfectly seal in four pennies. I use these bearings from Amazon. Remixed with Tinkercad: https://tinkercad.com/things/6Y7O9gK8yU5