Penny Board 1.0

myminifactory

I retain full ownership of this model under MMF copyright, so selling or uploading it elsewhere without my explicit consent is strictly prohibited. I stumbled upon someone attempting to replicate the Penny Board with limited success, prompting me to take on the challenge and emerge victorious. For optimal results, I recommend printing the pin at 100% infill and the remaining components with a moderate infill density ranging from 25% to 100%. The back section should be printed with an infill density between 75% to 100% for added strength. To assemble the Penny Board, you will need three steel rods with a diameter of 6.4mm: two measuring 43cm in length and one measuring 45cm. Printing support is not required. Watch this accompanying video for a clearer understanding of the process.