penis whistle

prusaprinters

one file contains the whole model if you want to print it as it is, but cant guarantee success when printing as i have cut the penis in half in my slicer so i could later add 6mm plastic ball inside and then superglued it. printed at 0,3 mm height with 0,4mm nozzle with Prusament PLA Galaxy Black edit: at the time of publishing i was high as kite and overexcited from this thing and it didnt occur to me at first… but im now printing it in one piece and just added a pause in print into gcode (with prusaslicer) so i can put the ball inside when paused… and it prints just fine without supports on both mk4 and ender 3 :Dnow printing at 0,15 layer height with 0,4mm nozzle on mk4 and at 0,24mm layer height and 0,6mm nozzle on ender 3 and it is fine on both. lol.the halving seems now overcomplicated and will off course affect the quality of the print, as its seen in the pictures. so i recommend you to try to print your whistle in one piece as it is!PAUSE in the gcode worked only with PRUSA! Later i discovered i need to enable this function in my marlin fw for it to work with Ender 3. This function is disabled by default in your Marlin firmware so be aware! I wasnt. It was too late and now i have just whistlin' dick with no ball inside :( In the end it works both ways and is pretty loud with high pitch noise which sounds amazingly annoying! just grab it by the balls and blow it from the back. and dont forget to give thanks to the original creators!