Penguin Rocker

thingiverse

A Little Weighted Penguin Spins Around Stress-Free. Print Settings: Printer: Prusa i3 Rafts: Doesn't Matter Supports: No Resolution: 0.2 Infill: 20% Notes: Designed to eliminate the need for supports, this model allows for any color combination desired. Be aware that printing one piece at a time requires critical cooling times, especially for a nice nose. Printing all three pieces simultaneously is recommended for good results. Any resolution is acceptable, resulting in different motion. Post-Printing: Minor cleanup only is required. One note about the weights: they must be centered and stable. Off-center or shifting weights cause a lazy bird that prefers to lie on its side. The model uses 1.75 filament pieces to hold parts together. With the exception of the nose, the model holds itself together without glue. This makes it ideal for testing weight combinations. If glue is used, only a small amount is needed for the filament struts. Glue can ooze outside the model if not applied correctly. Filament pieces don't need to extend fully into both halves. If gaps appear at seams, trim the filament or rearrange weights for proper fit.