Penguin Peril Game - Case

prusaprinters

<p>I printed the Penguin Peril Game which was released on Thingiverse from Polymaker.&nbsp;</p><p><a href="https://www.thingiverse.com/thing:5171512">https://www.thingiverse.com/thing:5171512</a></p><p>But I needed a case - so i draw one. You could store more stones that needed and two hammer.&nbsp;</p><p>Before you print check the fittings - do a test print - I provided a “cut” from the STL (Fitting_ test_print.3mf). Takes only 5 min and you know if you stones fit into the case easily.&nbsp;</p><p>I needed to go up in x and y for 3% - I did it direct in the slicer.&nbsp;</p><p>The LID is about 0,2mm bigger - for me it was fine. If you printer fail at a tolerance test with 0,2mm than you should increase X and Y for the Lid a little bit!</p>