Pencil holder

prusaprinters

<p>A pencil holder for 5 pencils. If you rotate the crank you can push the pencils up and down in any pattern you want. Of course it works also with a slim enough pen.<br/> The honeycomp pattern is not in the STL file! I used a modifier in PrusaSlicer, set the Infill to honeycomb and the top and bottom layers to zero. The model is fully functional without it.</p> <p><strong>Dimensions</strong></p> <p>Model (with baseplate)<br/> Height (without pens): ca. 80mm<br/> Width: ca. 60mm<br/> Length: ca. 120mm</p> <p>Holes for pencils:<br/> min. ca. 7.7mm<br/> max. ca. 8.8mm<br/> (you might be able to fit pencils which are on some points thicker than 7.7mm like hexagon shaped pencils)</p> <p><strong>Assembly</strong></p> <p>You need:</p> <p>1x Frame<br/> 1x Baseplate<br/> 1x Crank<br/> 5x Clip<br/> 1x Shaft</p> <p><strong>Note:</strong>If your 3D printer makes a thick elephant foot on small round objects use<br/> the normal "Shaft" STL for printing if not use the "Shaft with edge" STL. The<br/> edge/elephant foot is the endstop for the shaft.</p> <p>1.Push the shaft through the frame and push the crank onto the two tooths of the shaft.</p> <p><strong>Note:</strong>If the the shaft is to short, try pushing it through the other side of the frame.<br/> If the crank sits to lose on the shaft, rotate the shaft 90° and try again until<br/> it sits firmly</p> <p>2.Press the clips onto the shaft. You can rotate them as you like to create different<br/> patterns</p> <p>3.Finally push the frame into the baseplate, if you want you can glue them together.<br/> To prevent the whole thing from slipping you can glue rubber pads on the cutouts on the<br/> underside of the baseplate.</p> <p>Now you can place the pencils with the back down into the holes on the frame.</p> <p>Have fun :)</p> <h3> Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Creality</p> <p><p class="detail-setting printer"><strong>Printer: </strong> <div><p>Ender 3</p></div><strong>Rafts:</strong></p> <p>No</p> <p><p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div><strong>Resolution:</strong></p> <p>0.2</p> <p><p class="detail-setting infill"><strong>Infill: </strong> <div><p>20%</p></div><br/> <strong>Filament:</strong><br/> Janbex PLA <br/> <p class="detail-setting notes"><strong>Notes: </strong> </p><div><p>Any material does the trick.</p></div></p> </p></p></p> Category: 3D Printing