Pencil Case/Display stand

myminifactory

A simple pencil case/display stand that I made. Developed in Fusion 360. When the ring is at the top of its movement, the pencils are all vertical so that the long side of the case may be put on. When you twist it, it fans them out for display/use. Magnets I used are from OfficeDepot/Max, found here (https://www.officedepot.com/a/products/400047/Office-Depot-Brand-Magnets-Silver-039/). They are a simple press fit into the case files. The main body should press fit into the short side, which will act as a semi-permanent base for the stand.  Print Instructions: Print the movable ring first. Once that is complete, remove it from print bed. When slicing the main body, pause the print before it starts doing the top solid layers(closing the helix) and insert the movable ring. This is a little tricky but not impossible. Then resume the print.  No supports, 0.15 mm layer height, eSun PLA+.