Pen Holder 2 - by SPARX

cults3d

I NEEDED A FEW STYLUS HOLDERS FOR MY DESK THAT FITTED WITH THE THEME OF MY MODELS. IT WAS A RISK, SO IF YOU'RE OFFENDED, DON'T DOWNLOAD. THIS ONE WAS MODELLED AFTER MY WACOM STYLUS, 10MM THICK, COMING IN TWO VERSIONS: ONE PIECE AND TWO PIECES PRINTED SEPARATELY. IF YOU WANT TO SCALE UP OR DOWN, JUST PRINT OUT THE PEN HOLDER.STL FILE, THEN SCALE IT UP UNTIL YOU GET THE RIGHT SIZE FOR YOUR PEN. IF YOU SCALE UP BY 10%, LOAD THE FULL MODEL AND SCALE THAT TO 10% TOO, AND IT'LL BE THE CORRECT SIZE. I SHARE MY WORK SO OTHERS CAN ENJOY IT. PLEASE DON'T SHARE THESE FILES ON SOCIAL MEDIA OR OTHER WEBSITES, BUT LINKS TO THIS PAGE ARE OKAY. NO INSTRUCTIONS WERE NEEDED FOR THIS ONE, BUT CHECK OUT THE SLICER PICTURES. I ANGLED THE FULL MODEL AT 12 DEGREES SO THAT NO SUPPORTS WOULD BE LEFT ON THE FACE, AND FEWER SUPPORTS WERE USED AS A RESULT. PRINT THESE MODELS WITH VERY HIGH FILL AT 60% MINIMUM, AS THE HAIR HANDS ARE THE MAIN SUPPORT. SINCE THEY'RE EXPLICIT AND HAVE HIGH DETAIL, YOU CAN DISPLAY THEM WITH A SOLID POLE RATHER THAN A PEN, SO SCALING UP TO 80-100% IS POSSIBLE. ALL THE PARTS WERE PRINTED AND DEVELOPED TO PRINT EASILY. I MODIFIED THE PELVIS TWICE OUT OF THREE ALTERNATIVES, BUT IN THE END, IT PRINTED BETTER WITH THE LEGS SEPARATED. ALL PIECES HAVE BEEN TESTED AND PRINT FINE IF YOU FOLLOW THE SETTINGS IN THE PDF FILE. ALL MY MODELS ARE RELEASED ONLY WHEN THEY CAN PRINT PROPERLY. PLEASE DON'T REMIX OR "FIX" FAULTS IN THIS MODEL THEN REPUBLISH! IF THERE'S A FAULT, MESSAGE ME, AND I'LL FIX IT FOR YOU. I MAKE THESE MODELS FOR MY OWN COLLECTION, BUT I'M ALWAYS OPEN TO SUGGESTIONS OF CONTENT FOR MODELS COVERING THE DC AND MARVEL UNIVERSE AS WELL AS TV AND FILM CULT CLASSICS LIKE BARBARELLA. MESSAGE ME IF YOU HAVE ANY IDEAS! ENJOY THE PARTS ON OFFER. I SHARE MY WORK SO OTHERS CAN ENJOY IT. PEOPLE ASK ME WHY MY MODELS HAVE SUCH PROMINENT DETAIL (NOT JUST THE "BIKO" BITS) LIKE MUSCLE TONE, ANATOMY, AND CLOTHING. WELL, THEY'RE PRIMARILY MADE FOR MY OWN COLLECTION, SO I SAND THEM DOWN WITH FINE EMERY THEN SUBJECT THEM TO AN ACETONE VAPOR BATH FOR 60 SECONDS. THIS SEALS THE SHELLS AND MAKES A SMOOTHER APPEARANCE BUT REMOVES SOME DETAIL, SO I BUILD MORE INTO THE MODEL. HOPE YOU LIKE IT!