Pelea T5

thingiverse

Customized version of http://www.thingiverse.com/thing:16627 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=16627 Instructions Using the following settings: retainer_ht is set to 1.5 inches additional_tooth_depth remains at zero m3_nut_depth is adjusted to 2 inches pulley_t_ht is increased to 10 inches teeth are now 10 in number motor_shaft diameter is maintained at 9.52 inches m3_dia remains unchanged at 3.2 inches additional_tooth_width is set to 0.2 inches nut_angle stays at a fixed 90 degrees m3_nut_flats are set to 5.7 inches idler is turned off by default nut_shaft_distance is adjusted to 1.2 inches pulley_b_ht remains the same at 10 inches pulley_b_dia is increased to 20 inches only one nut is being used, specified as no_of_nuts retainer is set to 10 in number m3_nut_hex is set to 1 inch idler_ht is maintained at a fixed 1.5 inches profile is adjusted to setting 6