PEI Plate Stabilizer Bar for Lulzbot Mini

thingiverse

I designed stabilizer bars as wedges to prevent my build plate from sliding around during printing. They're working great so far. UPDATE... Eventually, my glass bed broke due to a nozzle issue that wasn't cleaned properly. The bed leveling washers weren't detected by the nozzle, which is unusual. I had recently replaced the bed-mounted connection clip for the heater because of temperature detection failures during printing. This new clip was tight between the glass bed and frame, causing a problem when the nozzle to washer connection was blocked. The nozzle continued pushing down while the clamp provided a pivot point in the middle of the bed. After upgrading to a new heater bed, I no longer needed these stabilizer bars and haven't had any issues yet.