Peggy's Coin

thingiverse

A customized model from Thingiverse, identified by number 127588. It was created using the Customizer application on Thingiverse. Below are some instructions and settings that were used to create this specific design. The model has several features: - Spacing: The gap between characters is set at a medium level of 0.7 units. - Relief: A high relief depth was chosen, giving the text some raised and embossed characteristics. This setting helps in adding depth and makes the text look more detailed. - Reverse bottom and top surfaces: For this model, the bottom surface is reversed to provide additional space on it, while the top is reversed in its position, so text sits upside-down relative to where you'd naturally place it normally. Design parameters: - Text height: This 3D printed item features large-sized letters at a height of approximately 4.5 mm above their baseline. - April 2015 - Printed bottom text message which was displayed under the model when laid down on flat surface in certain light conditions due its relief style. It would make quite big words depending upon scale and size setting applied during actual production run because then font becomes larger compared to other standard ones found typically there. - Top: A personalized engraved item with name 'Thorin Oakinshield', also positioned vertically opposite the April 2015 written part mentioned earlier above at same line level, forming horizontal alignment visually even if words have variable size. - Diameter of object itself being 39mm