Pegboard TP-LINK wi-fi adapter bracket

thingiverse

My printing operation is located in my basement where the WiFi signal isn't very reliable, so I purchased one of these devices to improve my reception, which seems to work quite well! This fits a TL-WN722N high-gain WiFi antenna (link provided), and mounts it to a pegboard with 1-inch hole spacing. The print shown in the pictures is a pretty snug fit for the adapter, which is fine because I can connect or disconnect the USB from the adapter with one hand if needed. You will need to print this with supports for the prongs. See print settings below. Thanks to twobraids, I used his prong design for this adapter bracket. Print Settings Supports: Yes Notes: Print with supports and at least three shells / greater than 1mm to make the pegboard prongs strong enough.