Pegboard Paint Holder Brackets

thingiverse

I've been utilizing a system for storing numerous paints using a peg board with metal grid shelving my wife had available. To create this, I recommend printing it at 100% infill and consider adding multiple supports on each corner based on the weight of the paint you're holding up. These are still under development but they seem to be functioning effectively so far. Feel free to modify or remix it as needed. This is a basic design. Initially, I printed them at 10% infill, but they snapped and dropped all my bottles onto the table. Luckily, there was no damage done and no paint spilled. That's why I suggest printing them at 100% infill and potentially having more than one support on each corner depending on how much weight you're placing on them. The lower set didn't quite match up, so I need to create another design for that. In the meantime, I wrapped some duct tape around the bottom set until the weight was properly supported. Working out good so far.