Pegboard Mounts

prusaprinters

<p>I designed these pegboard mounts to hold the board to the wall with the least material getting in the way of using the pegboard. The pieces can be screwed into the wall by lining up the holes in the mounts with the holes in the pegboard. All mounts are spaced to keep the pegboard off the wall with enough depth to allow for pegboard holes to be used with most pegboard accessories.</p><p>Corner - Self explanitory, you can use one or both of the screw holes here.</p><p>Edge - This can be used anywhere along the edge, I lined it up with the studs in the wall</p><p>Rear Support - This piece can be placed throughout the pegboard panel so it in not floppy in the middle. The way to mount it is to line it up at 45 degrees to match the pegboard holes</p><p>&nbsp;</p>