Pegboard Mounting Bracket for AC Infinity CLOUDLAB 642 Grow Tent

thingiverse

This is a mounting bracket to mount a 2' x 4' pegboard to the back poles inside of an AC Infinity CLOUDLAB 642 grow tent. Although they advertise the poles as being 1" in diameter, they're actually 7/8" (a little over 22mm). The inside diameter of the bracket where it attaches to the pole is 21mm. I designed this to have a tight fit because I want to be able to put a fair amount of weight on the board without it causing the board to slide down the poles. It does take a little muscle to install, and the bracket will need to flex a bit to snap onto the pole. I wouldn't use resin that is very brittle. In my print I used Siraya Tech Build. I have not been able to test this with a FDM printer yet. There is a slight offset required to make the holes line up perfectly. So. I have added some text to one side of the bracket "Outside Edge". This side of the bracket should face the outside edge of the pegboard when installed. You will need to print 4 brackets and 16 screws. I have only had this installed for about a day, so I can't make any guarantees about the long-term durability of this design