Pegboard mount for safety glasses

prusaprinters

<p>I got new safety glasses and needed to keep them somewhere safe. I use pegboard, so that was the perfect place. I looked at a bunch of the options available here (see below for a list) but none of them were quite what I wanted - most hold the glasses by the bridge, which might not work so well with these as they have rubber nose pads. So I created my own. The holder is quite long as these safety glasses wrap around quite a bit and wind up being pretty deep.</p> <p>This is designed for 1" pegboard with 1/4" holes.</p> <p>If you think it's just too big or don't like it for whatever reason, here are some other designs for holding safety glasses on pegboard:</p> <ul> <li><a href="https://www.thingiverse.com/thing:321835">https://www.thingiverse.com/thing:321835</a></li> </ul> <p>Square pegboard, won't work for me.</p> <ul> <li><a href="https://www.thingiverse.com/thing:3494592">https://www.thingiverse.com/thing:3494592</a></li> </ul> <p>Holds the glasses by the bridge, might not work with my glasses. (much smaller/faster print, though!)</p> <ul> <li><a href="https://www.thingiverse.com/thing:3977583">https://www.thingiverse.com/thing:3977583</a></li> </ul> <p>Probably the closest to the design I came up with. Might not have been quite long enough and I don't like having the pegs run across layer lines like that. Would probably be just fine, though.</p> <ul> <li><a href="https://www.thingiverse.com/thing:4430038">https://www.thingiverse.com/thing:4430038</a></li> </ul> <p>Another that holds it backwards via the bridge. Simple and quick print but to me that just doesn't look "right"</p> <ul> <li><a href="https://www.thingiverse.com/thing:4191179">https://www.thingiverse.com/thing:4191179</a></li> </ul> <p>Different sizes but still holds the glasses "backwards".</p> <ul> <li><a href="https://www.thingiverse.com/thing:3391285">https://www.thingiverse.com/thing:3391285</a></li> </ul> <p>A different option that holds the glasses by the earpiece. Nice, but I wanted easier access.</p> <ul> <li><a href="https://www.thingiverse.com/thing:3516318">https://www.thingiverse.com/thing:3516318</a></li> </ul> <p>Just a smaller pegs version of a previous thing.</p> <h3>Print Settings</h3> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>0.3mm</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>20%</p></div> <p><strong>Filament:</strong> eSun PLA white</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>Prints with no supports. You can do supports from the pegs but if you don't it'll just be a little messy under the top pegs, which shouldn't cause too much trouble. If it interferes with the holes, it's an easy cleanup.</p></div> </p></p> Category: Organization