Pegboard Container, with 'Opener Pick' Holder

prusaprinters

The container is 50mm wide x 35mm deep x 65mm high. I also attached a holder for those ‘opener picks’ or ‘prying chips’ that are commonly found in precision screwdriver sets. The holder can hold 5 picks. (FYI: The picks shown in my photos are of the same color as the filament used, don't let that fool you)I left the back blank for you to add your preferred mounting option. I use a generic pegboard plate to superglue onto the back wall of the model, this allows me to get the alignment right without precise measurements during the modeling process. Put superglue onto the plate, put the plate up on your pegboard, then press the model onto the plate.If you are here just for the pick holder, you can find the model at: https://www.printables.com/model/549639-prying-chips-or-opening-picks-holder