Pegboard Bin Hanger

thingiverse

I wanted to install a bunch of Akro-like bins on my pegboard. Several of the holders demand that you screw them into the pegboard. I needed the flexibility of being able to move the holders where and when I need to so I designed a bin holder that accomplishes that purpose. It is meant for pegboards with 1-inch spacing like those sold by Home Depot and other home improvement stores. I built it to meet my needs. Here are the instructions: Use these settings: The raft should be on, supports too. Set infill at 35 percent. This ensures the "pegs" will hold their shape. Three shells work best for this project. Keep the layer height at 0.20 millimeters. After it's done, take a few minutes to clean up and remove the raft and supports carefully with an xacto knife. Be careful not to damage any pegs during cleanup. Don't forget to clean the lower pegs on those small supports either. You may need to file them down slightly for a smooth fit in the pegboard.