Peg for robot mower perimeter wire

thingiverse

This is a peg for securing the perimeter wire on your robotic lawn mower. To be well-prepared, it's great that you can make these quickly if needed. If you require multiple ones, purchasing them pre-made will probably be more efficient. The design prints perfectly as is, without any additional support required. However, if you prefer a sharper tip than the natural overhang supported by your printer, then some support will be necessary. Precision isn't a concern here, so feel free to print with thick layers that your printer can handle. Since these pegs are inserted into the ground, they need to be made of a durable material. ABS is likely a good choice. PLA may also work, but it might not last as long. The design is parametric, allowing you to adjust how solid and rigid the plugs turn out to be. Some alternative designs can be found at: http://www.thingiverse.com/thing:407483 http://www.thingiverse.com/thing:1028268 Print Settings: Printer: Bukobot Rafts: No Supports: No Infill: Very close to 100%