Pebble Time Charging Stand

thingiverse

Inspired by another charger for Pebble Time, this one takes a slightly different stance, elevated from its peers. It features an expertly designed cutout at its base that cleverly accommodates coins, granting added stability through the weight of these inserted pieces. The assembly and production of this device are made straightforward with precise instructions: I produced the design using PLA material at a resolution of 0.2mm layer height with 3 perimeter layers in place. A moderate infill density is preferred, approximately around 30%. It is advisable to print the charger on its side, eliminating the need for supporting material. To keep the charger secure and snug in place, I applied an adhesive tape made from painter's tape to the surface of the device. Subsequently, twelve pennies were hot-glued into the base to reinforce stability within this charging stand.