Peak Design Mobile to Capture V3 Adapter

prusaprinters

Update 6/29/22: Added a version with a centered ¼-20" thread and no boss (i.e., MagSafe compatible). Use caution – this will be less secure than the SlimLink version.Update 4/27/22: Added a version with a centered ¼-20" thread A magnetic mount to adapt Peak Design's Mobile Case standard straight to their Capture V3 clip product in a single part.Requires 4x 10mm x 3mm refrigerator magnets and a pause at the appropriate layer to embed them in the print.I recommend you use Peak Design's Mobile case and retain the small square boss on the phone side of this adapter – this will make the magnet joint much stronger by preventing sliding in any direction.This should also be compatible with MagSafe natively without a Peak Design case if you remove the boss, but I haven't tested it and wouldn't recommend it for actually carrying a phone on a Capture – not secure enough IMO.My first print so far with this design was with:- Prusament PLA Galaxy Silver- 0.15mm layers, QUALITY preset- 4 perimeters- 30% gyroid infill- supports to the base only- printed with the boss/phone side down on the plate