Peak Design Mobile Continuity Camera Mount for 2021 MacBook Pro

prusaprinters

A magnetic mount to adapt Peak Design's Mobile Case to an 16" MacBook Pro (2021) for use with Reincubate Camo or macOS Ventura's forthcoming Continuity Camera feature.Requires 4x 10mm x 3mm refrigerator magnets and a suitable pause at the appropriate layer to embed them in the print.I recommend you use Peak Design's Mobile case and retain the small square boss on the phone side of this adapter – this will make the magnet joint much stronger by preventing sliding in any direction. This should also be compatible with MagSafe natively without a Peak Design case if you slice off the boss from the center of the magnet side of the mount, but I haven't tested this.The spacing of the lip on the clip piece can be easily tweaked to accommodate other laptop lid thicknesses (MBA, etc.). I may add more later as I have access to measure myself.Note there are multiple locations on the magnetic mount where you can secure the clip. Depending on the size/generation of your phone, one may be more appropriate than the others in order to mount the camera as close to your screen as is practical. The attachment is intentionally stiff and tight – once it's snapped on, you may not be able to get it off easily without causing damage.My print (GCODE available here) of this design was with:- Prusament PLA Galaxy Silver- 0.15mm layers, QUALITY preset in Prusa Slicer- 4 perimeters- 15% gyroid infill- no supports- printed with the broadest flat sides down on the plate