pcDuino V2 Board Drilling And Mounting Plates

thingiverse

This device houses a baseplate and drilling guide designed specifically for the "pcDuino V2 Board". Note that the plates lack symmetry; a notch should be located on the side where the USB connectors reside. The baseplate measures 2 mm in thickness. For attaching the board to its mounting plate, screws of M2 type with a 5 mm or 1/4″ (4-40) size will be necessary. Three mm diameter holes can be found in the mounting areas; however, these do not extend through to the bottom layer for printing purposes and therefore must be drilled individually.