PCBite Probe Holder

thingiverse

I got tired of cats knocking over the probes when not in use, so I put together a little holder for them. This is designed to fit four of the SP200 probes, but I suspect it'll fit just about any. In order to keep it from tipping, there's a magnet holder for a 60mm x 10mm x 5mm magnet. This is the one I'm using: https://www.amazon.com/gp/product/B072K5SLXK/ Note that the magnet cover is a tight fit. Depending on your printer, you may want to either sand the sides or scale it down.