PCB Board Stand QTC Nixie Clock

thingiverse

I had purchased some years ago a QTC Nixie Clock kit from PVElectronics, mostly assembled but left unfinished. Recently, I picked up where I left off, as all that was needed were the LEDs and a case to complete the project. My objective was to get it set up and running again. To achieve this, my setup required having the tubes mounted separately, necessitating a mount to hold the board in place temporarily. My board is an older model from September 2012, but its dimensions remain unchanged for current QTC boards. This mounting solution may also work for other PCB boards with similar specifications, using M3 screws and measuring 49mm x 153mm between each hole (55mm x 159mm overall board size).