PC style Computer Case Raspberry Pi Compatible

thingiverse

This is a PC style computer case for the Raspberry Pi or compatible Single board computers. It is three parts, no screws required, but intended to have 1/8" glass panels glued into the 3 open sides. It supports two 40x10mm fans in the front holder, no screws required. There are pass through holes for HDMI and power. 90º adapters must be used for these cables to fit inside the case. The mainboard snaps into the mainboard tray, which slides into the back of the case and should lock in place. The fan holder is separate and will snap into place, do that before installing glass panels. For best results, try changing part orientation. Fan holder flat side on the bed, Mainboard tray with flat side down, or with the "L" shaped side facing down on the bed. The outer case prints best at 45º, the rear lower corner to the bed. Tree supports are recommended for ease of removal. Bottom of case is smooth, intended for self adhesive feet. *** Hold tight, revisions in the works*** *Adding an optional carrying handle. *Revising side panel to open like a door, fans are impossible to access from rear opening only. *Mainboard tray will interlock with fan panel for structural stability.