PC / ATX Power Supply Mount (Remix)

thingiverse

I modified the original holder by Rapsss as my power supply was slightly smaller in size. The port for the wall plug was raised, causing the upper left brace to break, so I cut a notch into it and added some thickness to that side to compensate. I also had to move the bottom supports to accommodate the cables. Further adjustments may be needed around where the frame screws into the power supply since the holes were slightly too small for my screws. In fact, I broke the upper-right arm near the screw hole. Additionally, the mounting holes for the frame to the Anet were off by a fraction of a millimeter, requiring some effort to bolt in properly. This could have been a problem with my printer rather than a design flaw itself, but I love the original design and it just didn't fit my power supply perfectly.