Paw Print

thingiverse

Simple, relatively flat, three-tiered paw print design that can be used for pretty much anything. Especially with magnets for a locker or refrigerator. Print Settings Printer: Dremel 3D Idea Builder Rafts: Use them or not, it doesn't matter. Supports: Same thing, they're not necessary. Resolution: Set the print to high detail. Infill: Start with 35% of material filling. Notes: To achieve a two-color effect, use one color until around 70%. Then watch closely and pause when the third tier begins. Switch to the second color quickly and continue printing. It's helpful to start with darker colors at the bottom and lighter ones on top, so if you switch too late it won't be noticeable. Switching later is better because an extra layer can hide underneath while a layer above sticks out if switched too early. Takes about 20 minutes.