Patrick with a happy face (A thank you model).

cults3d

Hello all, i was thinking about giving away an unique 3d printable model to the people, who tipped me, as a thank you gift for a long time. i have spent some time for modeling a "happy face" patrick and its finally done today. I found out, that the implementation of the tipping functionality of thingiverse is not so good, the users who tipped me are not shown in control panel later. If you tipped me and did not contact me, please write a short message with your wish name (please read down about it) and your tipped amount. There are only few donators, so i will surely remember you by reading above message. Back to the model: You can say your wish name and it will be written on the board. more than 9 characters will cause the text appear smaller, please think about that. The model will not require any support. Please also remember, customizing the text isn't one-click-and-ready thing. So please allow me some time to make it. But it won't take long, i promise. After its done, i will send you the printable model. Again, thank you for supporting me. The uploaded model (mouth) is only for testing, if your print would fail at the mouth area. Its the most problematic area (for printing without any support). If it does not fail, the entire model should be fine.