Patio Swing Cup Holder

thingiverse

I'm not sure why anyone would create a swing without a place to hold their beer, but that was the dilemma I found myself in. If you find yourself in a similar dark situation, have this exact swing design, possess a 3D printer, have an abundance of filament, and have around 4 hours to spare, consider yourself extremely lucky. The gap between the back and front of the swing is approximately 19mm. The front section (honeycomb pattern) hangs down about 95mm, and the hole for your cup is roughly 75mm in diameter. Print Settings: Printer: Voron/Ultimaker Hybrid Rafts: No Supports: None Resolution: 0.4mm Infill: 25% Notes: This print should be relatively straightforward if you keep the orientation of the STL file (oriented on its back). Be cautious with bridging at the top, as it's a narrow gap.